The operation of the optical fiber cutting knife methods and steps,

fiber cutting knife operating methods and steps of: 1, confirm the device with the sliding plate in front side of the blade open the platen size; 2, with peel fiber pliers strip optical fiber coating layer, set aside for 30 - long naked degrees Dip in 40 mm, with alcohol cotton wool or cotton paper fiber, then wipe off the fiber. Use absorbent cotton or cotton paper to wipe a, don't use the same cotton wool or cotton paper to wipe the second ( Note: please use the pure degree of greater than 99% alcohol) 。 3, visual optical fiber coating layer edge alignment on cutter scale ( 12 - 20cm） After the appropriate scale, the left hand to press the fiber into the guide groove, require bare fiber straight on the left and right rubber MATS. 4, close the small plate, pressure plate, driving device with blade slider, make blade row cut fiber under the surface, and free sliding to the other side, to cut off the fiber; 5, the left hand to hold the cutter, the right hand to open the clamp and remove fiber debris, in fixed container. 6, knead a optical fiber at the same time, the right hand with his left hand to open small clamp, carefully remove the cut end face of optical fiber, note: clean the fiber cross section and don't touch it. Note: 1. Please read it carefully before use optical fiber cutting knife product manuals; 2 use fight fiber debris into the skin, eyes, optical fiber elastic please use special container collection; 3 please do not directly touch the blade with the hand, also don't touch when maintenance and blade; 4 please don't fold the cutter or to its oil, need repair, please contact our after-sale service department; 5 cutting knife, into a special box and properly keep in a dry, clean place.