Reason and solution of “Fiber tracking failure”

When splicing the fiber, will you meet the fiber tracking failure?

There are several reasons caused the failure:

Dust on lens

Pressure hammer not working precisely on pressing the fiber

CMOS board malfunction

  Dust on CMOS BOARD

How to solve the problem?

   Firstly, lets check if V-Groove is clean or not?

The pressure hammer tip point is not on the V-Groove and not pressed on fiber

  Under normal circumstances, tip point of pressure hammer should be exactly on the central point of V-groove and press on fiber

  Solution:

Loose the screw on pressure hammer and adjust the pressure hammer position, ensure the tip point is exactly on central of V-Groove and press on the fiber.

   Splicing again after adjust, looks like the splicing is succeed. Problem fixed.

Tumtec is an independent manufacturer for automatic fusion splicers and fiber cleavers;

Tumtec fusion splicers covering backbone project, single core alignment fusion splicer, FTTX fusion splicer and newly released ribbon splicer.

Newly released: 2019 for portable splicer FST-V1 and 2020 for FST-12R.