You should pay attention to the following welding machine construction

some skilled workers in the optical fiber welding machine construction, find it difficult to grasp, find it difficult, construction workers in long-term practice will actually had a technology, skilled in the later will be very convenient, not familiar with the people because of the experience will be less so. You know, in the welding machine for welding construction when there are many steps need to cause our attention, inadvertently omit some of the steps, or a lapse after operation in place may make poor welding results. Small make up to today and everybody said we should pay attention to what point in the welding process.
1, stripping the coating layer of the fiber and fiber cleaning
this is welding the step of the fiber, but it is also quite important step, if the cleaning does not reach the designated position can bring a lot of trouble to the back of the welding, such as dust combustion, optical fiber migration in V groove a fixed position, eventually lead to loss of welding. So when clean fiber needs to pay attention to the following:
a. Use the
b a purity of more than 99% alcohol. Clean every time to replace
c gauze or a clean paper. Start by stripping the edge of the coating layer part clean
d. Wipe until the 'Q', 'Q' sound wipe again after a few times
welding machine construction you should pay attention to the following
2, using the optical fiber end face of the cutting processing cutting knife after
clean the fiber can be cutting, cutting before welding is the purpose of to deal with the end of the fiber, so after cutting Angle will directly affect the weld of loss, and the cutting Angle is too large you will call the police, when welding welding to reduce welding success rate. In the process of cutting should pay attention to the following:
a. Confirm the coating layer not in rubber mat
b above. If the rubber pads to glue on both sides of the up and down on the optical fiber scraps dirt, be sure to use alcohol wet cleaning of cotton swab
3, place the optical fiber to
cut after completion of the welding machine can put the fiber in our welding machine to the inside, when placed in the optical fiber to the following graphic way to deal with, when placed in the optical fiber has some attention:
a. If coating layer produced inertia bend, bend down direction placed
b. To prevent fiber tip deformity or adherent dirt, please do not make the top of the optical fiber and V groove or electrode contact
4, welding operation after
fiber in place, you can proceed to our optical fiber welding, welding process will be done by automatic machine, but it also needs to have some attention.
a. Confirm discharge through the screen. Discharging, image swung, brightness change, show that discharge is not stable. For [ Discharge correction] ( Stable electrode] , make the discharge stability.
b。 Please do not pull fiber when welding. No side can lead to bad welding
5, heat shrinkable tube heating
welding is completed and the last step, it is through the heat shrinkable tube parts of the optical fiber bare, also in the process of operation also need to pay attention to:
a. Keep the slight pulling the state of the fiber, the fiber to fiber heater welding machine.
b。 Please do not make the bare fiber parts in contact with the electrodes and other welding machine other parts of the
c. Transfer note don't twist fiber
d. Confirm whether melt contact in the center of the heat shrinkable casing
e. The center of the heat shrinkable casing placed in the center of the heater

welding machine above content can be a bit more, a new entry-level workers may feel a little boring, but this is all in our daily welding machine welding really need your attention in the construction process, and only master the basic knowledge, to improve your skills. Small make up of optical fiber welding machine, welding speed, low energy consumption, quality excellent, with our perfect service look forward to cooperating with you.