Welding machine in the maintenance of the ways to make optical fiber welding machine to reduce the loss?

Welding machine in the maintenance of the ways to make optical fiber welding machine to reduce the loss? In a lot of the welding machine repair industry, the failure many reason is because of the product of equipment caused by incorrect operation; So in a lot of time, in order to reduce the number of welding machine maintenance, effectively reduce the loss of fiber connection; Need to be done at the time of use right; So how to use is correct? Optical fiber welding machine brand Germany colorful welding machine advice: correct reasonably set depending on the type of optical fiber welding parameters, the pre discharge current, time and andadministrative electric current, andadministrative electric time, etc. , and in the use and remove the dust in the welding machine in time after use, especially within the fixture, the mirror and v groove dust and fiber flakes, remove; Before each use should make optical fiber welding machine in welding environment placed at least 15 minutes, especially in a place with a greater difference between using the environment ( As well as indoor and outdoor) in winter , according to the time of the pressure, temperature and humidity environment, reset the discharge voltage and discharge position of welding machine, and to reset the v groove drives, etc. 1. Every day before going to use welding machine, discharge test is done first, after discharge test OK, can be used normally 2. Use daily after welding machine, take a swab with alcohol ( The purity of 99. More than 5%) Wipe the mirror, microscope, V groove etc. 3. Be placed in a dry place, and shall not be put in the dark. Humid place. Within certain parts should not be stored in a humid place. 4. Long time didn't use welding machine, regularly, taking out welding machine, stay on about 30 minutes, stay inside the machine dry.