Simple optical fiber welding machine malfunction analysis and ruled out,

Optical fiber welding machine breakdown analysis and simple - 2016 06 - 8 A, optical fiber welding machine in welding process display & other; Can't find the fiber or fiber end face untidy & throughout; 。 This is mainly caused by the pollution of surface of the optical system, should be protected with anhydrous alcohol clean glass ( Located just below the electrode) And at the same time clean fiber cover the lens. After wait for alcohol dry and then to weld. If the fault can't be ruled out, the machine need maintenance repair service center. B, optical fiber welding machine in welding process to show & other; Optical fiber migration is too big & throughout; 。 The main cause of this situation is caused by the V groove groove with dirt, need to clean the V groove. Clean in the anhydrous alcohol to clean, can use toothpick or high pressure within the tank on stolen goods to clean air, pay attention to, not with hard objects to clean operation of V groove, so easy to cause damage of V groove. If can't eliminate after cleaning & other; Optical fiber migration is too big & throughout; Tips to drive recovery, also can't repair, artificial regulation requires repair service center. C, fiber found in welding process, welding part is unusual, electrode discharge is not uniform. This is mainly due to the tip of the electrode is oxidation, because of the existence of tip with oxide electrode made uniform discharge units, welding quality is bad. Need to clean the electrode. If can't normal discharge after cleaning, you need to replace the electrodes. In general, the electrodes in welding need to clean the electrode 500 times or so, in the use of the 1000 or so you will need to replace the new electrode. When replacing electrode electrode, please use the original factory use other can't guarantee the normal work of the function of welding electrodes, it might damage the welding machine. D, optical fiber prompt replacement electrode welding machine. This is due to set up a reminder to replace electrode welding machine Settings, please clean the electrode when prompted to replace electrodes, at the same time, can enter the welding machine parameter Settings in the changes of the parameters. Standards set for 1000 times. E, battery life, reduce fiber welding machine battery and mobile phone battery, need to pay attention to using method, under normal circumstances, the battery capacity is above 30%, please use the battery power supply. Please note that at the same time, in the use of alternating current power supply, will be for the welding machine battery charging. After found that battery life, can be three times the depth of the charge and discharge the battery, so the time of the battery can be extended. Once found the battery fast charge, and shorter working hours, please to three times the depth of the charge and discharge, if cannot be ruled out fault, indicates that the battery life to the limit, need to replace the original rechargeable battery, replace the battery, please contact the service center. F, battery power supply mode optical fiber welding machine cannot boot. In performance: please make sure the power supply device before starting the alternating current (AC), from 90 to 260 v, AC 50/60 hz. At the same time, please ensure that the battery is connected to the power adapter is normal, if the connection is normal circumstances are still unable to boot, you need to send several summary electrode maintenance center repair replacement must be replaced in pairs. In general the alternator will produce the output of the abnormal high pressure and irregular frequency, connect the welding machine must be after the output voltage stability, to use again. The best equipped with stabilizer. Do not use hard tools such as metal clean fiber clamping device, optical alignment device and optical imaging system. Do not adjust the welding machine internal correlation of specified changes the values of the parameters.