Optical fiber welding machine use points and the solution to the common faults

fiber welding machine is a small portable welding machine, the use and operation is very simple, but because of the bad optical fiber welding machine working environment, hard to avoid can appear some problems after using for a long time, for some have no experience of construction personnel, these problems will become difficult and affect the normal use. Now for the common problems occurring in the use of daily do some instructions, hope can help the telecommunication engineering personnel to improve the efficiency of construction. Optical fiber optical fiber cutting and clean stripping, ensure the optical fiber coating layer after stripping residue has been cleared, then dip in with alcohol ( Concentration for more than 99% of anhydrous alcohol) The gauze or enough soft tissue wipe off the fiber. For cutting the fiber to make sure the correct cutting length, generally take to cut off the long in 10 mm to 16 mm is better, optical fiber cutting length is too short, welding machine can't work normally.

fiber welding machine

right place the prepared fiber optical fiber in V groove, to ensure that the fiber on the bottom of the V groove, and the end of the optical fiber on the verge of V groove and between the electrode tip. If due to memory effect to fiber bending and placed when optical fiber bending part up. Be careful not to make preparation of good optical touch anywhere in order to assure the quality of the optical fiber end face. 3, welding mode choice for general FTTH ( Most) Construction, as long as select machine factory default Settings, SM - namely SM can, if the weld mode selection error, so will be unable to guarantee the quality of welding. Heating time of the modified

machine factory have default heating time, but because of the heat shrinkable casing material and using the environment temperature is different, the heating time difference. According to observe the effect of hot shrinkage, can change the heating time, the corresponding Heating time in the heating mode menu) To ensure a hot shrinkage success. Lenses, contamination or damage may result in high welding loss or bad connection. So, shall regularly clean two objective lenses, will continue the accumulation of dust and eventually won't be able to eliminate. Specific steps are as follows: 1. First of all to shut off the power before cleaning lens. 2. It by a thin cotton swabs with or without alcohol gently wipe the objective lens. Since the middle of the lens with cotton brush, do circular motion, has been to spin out the edges of the lens, be careful not to encounter V groove. 3. With a clean dry cotton finally wiped legacy of alcohol.