Optical fiber welding machine parts of the optical fiber cutting knife use method and the blade adjustment method

Optical fiber welding machine parts of the optical fiber cutting knife use method and the blade adjustment method of optical fiber welding machine accessories fiber cutting knife use method and the blade adjustment methods: optical fiber cutting knife is good or bad directly affects the welding quality of the optical fiber optical fiber welding machine, so choose a good optical fiber cutting knife and the correct use of optical fiber cutting knife is essential; Of course in good cutting knife also need to adjust in use after a period of time. Optical fiber cutting knife is used for cutting thinner than a human hair fiber, optical fiber cut into what is perfect? Cut fiber amplified replacement level or near to the whole, to use mechanical joint or optical fiber welding machine welding machine for welding machine: the method of use: 1, the optical fiber cutting knife device has a blade slider on the front, open cutting knife on the plate. 2, optical fiber cutting, stripping pliers to remove fiber covering the surface of the coating layer, length of 30 - 40 mm, with a purity in 99% alcohol to wipe fiber cotton, use absorbent cotton or cotton paper to clean once, don't use the same cotton wool or cotton paper to wipe the second time. 3, visual optical fiber cutting knife edge coating layer on the cutter rod ( 12 - 20cm) After the appropriate scale, the left hand to press the fiber into the guide groove, require bare fiber straight on the left and right rubber MATS. 4, close the small plate, pressure plate, driving device with blade slider, make blade row cut fiber under the surface, and free sliding to the other side, to cut off the fiber. 5, the left hand to hold the cutter, the right hand to open the clamp and remove fiber debris, in fixed container. 6, knead a optical fiber at the same time, the right hand with his left hand to open small clamp, carefully remove the cut end face of fiber cutting knife, note: clean the fiber cross section and don't touch it. Fiber cutting knife blade mouth adjustment method: fiber cutting knife after repeatedly cutting blade can produce consumption, cut surface defect phenomenon. If continue this phenomenon occurs, it is necessary to adjust the position of the blade mouth to follow the steps below to invert the blade direction, use a new blade. 1. Please use the flat screwdriver will be fixed blade screws loosen. Will be turned into a new optical fiber cutting knife edge blade. With cotton bar hold down the side of the optical fiber cutting knife blade or apex to outside, is easy to turn the blade. Note: ( 1) When replacing the blade position rotating blade, please do not use hand direct rotary blade. ( 2) Do not use metal tools ( Tweezers) Turn the blade. ( 3) If use metal tools, can damage the blade. 3 screws, gently tighten the fiber cutting knife, modest, not too tight nor too loose, leave all elastic limits, convenient adjustment. 4. Try to cut after 3 to 4 times fiber, could detect the cutting section of the fiber optical fiber welding machine, if the optical fiber cutting knife section is still not enough good, to the new adjust the height of the blade.