Optical fiber welding machine maintenance of common sense

the daily maintenance of optical fiber welding machine maintenance of optical fiber welding machine as high in the process of the fiber connection tool, is often used in the environment is relatively harsh environment. Proper maintenance is helpful to improve the service life of the optical fiber welding machine, can make it work better. If you have a optical fiber welding machine hand, so have to maintain it in time? The following daily maintenance for welding machine, Suggestions are given.

1
to clean! Clean! Clean! Important things about time, never enough.
a. The cleanness of the whole machine
as often go to do the inspection for our clients, socially responsible company engineers are well informed. Some welding machine, it was a gloomy. Welding machine for more than a few years of dust on the shell. Although the fiber in the environment not clean, but if in the long run, dust fall into the machine, dirty V groove, corrupt the lens, the motor, this is what to do? ! So, usually with a cloth or wet towel to wipe of the welding machine shell, and exposed to the surface of the part, gas blow the dust, and it won't take too long time.
b。 The cleanness of V groove
V groove is an important component in welding machine, its role is fixed and support about welding in the optical fiber. For the daily maintenance of welding machine clean V groove is one extremely important step. Cut fiber end face tilted back and forth tong to V trough and dust.
c。 Optical fiber presser foot and clamp fixture clean
as a direct contact with the optical fiber on the surface of the part, there is dirty thing can affect the alignment of the fiber. So, often should use cotton swabs dipped in alcohol to wipe the
d. Electrode clean
after welding machine used in the long run, arc discharge gasification will make part of the optical fiber, glass after gasification part adhere to the surface of electrode, after a long time will affect the discharge electrode. After cleaning alcohol cotton with burnish of fine sand paper to wipe.
e。 Lens clean when there are dust on the lens or are attached to the lens optical fiber after gasification, affects the alignment of the fiber, alignment time to extend or can't aim at the situation, and estimation of weld loss can have influence. Clean to unload electrodes, and then use cotton swabs dipped in alcohol, outward from the center to the spiral looped way to wipe.
f。 Cutting knife cleaning
use dipped in alcohol swab to wipe fiber respectively clamp block, anvil block and blades. Remember when optical fiber debris or cutting Angle is greater than 3 degrees on the clamp block should be clean.
2 electrode rods to replace
they must often change oh. Optical fiber welding machine is generally recommended to change the time 3000 times or so. To note here is that you want to use fused fiber machine equipped with fixed electrode under the screwdriver, gently twist of the screw, don't be too hard!

3 discharge correction using frequency, recommend a discharge calibration tests every day. Otherwise, a discharge correction before each use. Remember, when the welding machine to travel long distances, or temperature and humidity, altitude, etc have severe changes, to discharge correction.
4 blade position change, the adjustment of the blade height
fiber cutting quality is closely related to fiber loss, in order to realize the low loss, good cutting quality is also need to guarantee.
welding machine like a used car, to take good care and protection, so as to improve the service life of it. In addition, we suggest that the welding machine each use a year or so, it is best to welding machine to manufacturers or agents for an inspection and maintenance.