Optical fiber welding machine how to maintain?

fiber welding machine application is more, for the maintenance of the way you understand? Below small make up just to share with you the following optical fiber welding machine maintenance methods:

fiber welding machine cleaning tools ( Commonly used) : cotton, cotton swabs, fiber itself, and the air balloon, alcohol, Ditto)
need to clean the parts:
fiber welding machine presser foot: dip in with cotton buds alcohol in the same direction to wipe the
V groove:
sumitomo special cleaning tools, no words can use alcohol bar, bare fiber can also be used to clean, general multi-purpose air balloon blowing, but avoid blowing with my mouth, did not have the moisture. Clean V groove

the direction of the welding machine adjustable core driving range up and down the only tens of microns, foreign body slightly makes the
fiber image deviates from the normal position, can't normal alignment. This time should be timely clean V groove, specific process is as follows:

1, the wind cap welding machine.
2, open the optical fiber head and holder pressure plate.
3, with cotton rods with anhydrous alcohol ( Or the toothpick sharpening) Single direction wipe V groove, can.
note: avoid by all means use hard clean V groove or force the V groove, avoid bad V groove or make the V groove misalignment, instrument cannot be used properly.
optical system for optical fiber welding machine: LED lights

the CCD camera
stick to wipe clean with alcohol