Optical fiber cutting knife adjustment method

fiber cutting knife used for a long time there will be some problems, such as in the use of optical fiber cutting knife will be the problem of how to adjust, just look at the below small make up for its adjustment method is introduced.



1, confirm the device with the sliding plate in front side of the blade open the platen size;
2, with peel fiber pliers strip optical fiber coating layer, set aside for 30 - long naked degrees Dip in 40 mm, with alcohol cotton wool or cotton paper fiber, then wipe off the fiber. Use absorbent cotton or cotton paper to wipe a, don't use the same cotton wool or cotton paper to wipe the second ( Note: please use the purity is more than 99% alcohol) 。
3, visual optical fiber coating layer edge alignment on the cutter rod ( 12 - 20cm) After the appropriate scale, the left hand to press the fiber into the guide groove, require bare fiber straight on the left and right rubber MATS.
4, close the small plate, pressure plate, driving device with blade slider, make blade row cut fiber under the surface, and the free sliding to the other side, to cut off the fiber;
5, the left hand to hold the cutter, the right hand to open the clamp and remove fiber debris, in fixed container.
6, knead a optical fiber at the same time, the right hand with his left hand to open small clamp, carefully remove the cut end face of optical fiber, note: clean the fiber cross section and don't touch it.
that is optical fiber cutting knife adjustment methods, in the actual operation of uncontrollable factors, so as to avoid fiber cutting knife damage.