Clean the fiber cutting knife and cutting blade adjustment steps in detail

Clean fiber cutting knife and cutting blade adjustment in detail steps 1 welding machine cutting knife cleaning: if the cutter blade, rubber gasket, or anvil block become dirty, may cause the loss of cutting quality and make the fiber surface or surface become dirty, which resulted in increased splicing loss. With glue alcohol swab to clean the cutting blade, rubber gasket, anvil block. 2 cutting blade regulate if cutting blade wear or damage, even clean the blade can reduce the quality of the optical fiber end face, the blade should be not wear location in to the next. Recommend replacing electrode in the same time interval to the position of the rotary blade. Eyelid is divided into the blade edge cutting knife, the height of the conditioning ( Note: general condition is not allowed to regulate height! ) , the pressure off the nursing methods of optical fiber. Regulate the cutting knife need to prepare tools: freshman screwdriver, inner hexagon spanner. Ways when I: blade mouth mouth after many times of cutting blade, blade mouth can produce consumption, will be cut cut surface owe good, cut constantly. This time it is necessary to adjust to the position of the blade. Note: the blade with a total of 12 points can regulate when one point cut owe good, can change to another point. Conditioning process: use a screwdriver to fix the blade screw loose. With the hand holding the knife will rotate counterclockwise 1 to 2 points. Keep an eye on the hand do not touch the blade marginal, easy to cut and damage the blade. The blade fixed screw with a screwdriver. II: the blade height adjusting often occurs when cutting knife cut constant conditions ( Regulate the blade is invalid) When the blade height could be prepared. Process: 1. With the fixed screw, hexagon wrench unscrew the rest 2 star. See below: 2. Put a piece of bare fiber on fibre channel, the optical fiber pressure. Regulate the blade could just touch fiber as the specification. Below: with the smallest inner hexagon spanner slight twist that adjust the height of the screw clockwise ( Screw to raise the clockwise and counterclockwise to lower) 。 5. See below: Stop to adjust height when the blade could just touch fiber. The height is adjustable. Try 2 times, will rest after confirmation can be cut set screw ( 2) Tighten the can. 5. 2. Three pressure off the adjustment method of optical fiber when cutting knife appear repeatedly broken fiber can consider is the height of the fiber channel and the rubber gasket ( Black) Don't agree. Adjustment process: put a piece of bare fiber on fibre channel, observe the difference in height between the fiber and black rubber gasket. Download of the normal fiber and rubber gasket highly consistent. If the height difference is too large will be broken fiber. Judgment after good height can be observed close to the load of fibre channel first rubber pad with and without defects, depression, etc. If there is need to replace the rubber gasket, if there is no need to adjust the fiber channel. If close to fibre channel ( On the left) Have sunken or defect, rubber pad can be temporarily replaced, intermodulation (see below, about Switch will have four screw down again after tight) 。 Adjust the fiber tank general conditions considered load fibre channel is not fixed or fibre channel deformation will first load of fibre channel set screws, fixed from scratch, try cutting. If the fiber was broken will screw, observation have fibre channel without deformation ( To both ends of tilted slightly) , if have the pull is forcibly with the hand, from the fixed screw.